DeLuxe Stitcher IMSHP-A25, Руководство по эксплуатации и обслуживанию

Страница: 20 / 56

18
Removing and Replacing the Wire Cutters (Figure 10)
The Wire Cutters (9048) have
two cutting surfaces, each of which
may be used by reversing the ends
and positioning in the Face Plate
(2132BA). To change or reverse
the Wire Cutters, they must be
removed from the Face Plate.
Loosen the Screws (UA2305.2) in
the Face Plate Clips (9056) and the
Screw (0084) in the Solid Face
Plate Clip (9171). Once the clips
are
loosened, the Face Plate can be
tilted away from the Bonnet
(2601R) to remove the Wire
Cutters. Slide the existing or new
Wire Cutters into the cutter holder
in the Face Plate - with the tongue
of the upper cutter facing the front and the tongue of the lower cutter facing the back and into the
Wire Cutter Operating Slide groove. Before tightening the Face Plate Clip Screws (UA2305.2) and
the Solid FacePlate Clip Screw (0084), make sure that each Cutter has slipped into position in the
Face Plate and in the Wire Cutter Operating Slide. (9049) Press the Face Plate under the Face Plate
Clips and tighten the Face Plate Clip Screws. Always rotate the MiniStitcher manually before
switching the power on to ensure free mechanical movement. This will prevent serious damage to
the Head.
Figure 10 - Removing the Wire Cutters
!
Always disconnect the power supply before
assembling the MiniStitcher or making any adjustments.

CAUTION
!
9049
2132BA
9048 (2)
9056
UA2305.2
9171
stitcher head. Remove the Wire Guide Spring (MG10009A) from the Wire Guide Spring Bracket
(MG10001A).
Loosen the Bonnet Clamp Eccentric Handle (9003A) and remove the Stitcher Head from the
MiniStitcher. Place the Head on a clean work area. Be aware that the Driving Shaft Connection Link
(2215) is removed from either the Driving Slide Assembly (2137A) or the Crank (MG10031A).