DeLuxe Stitcher IMSHP-A25, Руководство по эксплуатации и обслуживанию

Страница: 12 / 56

Adjusting the Length of the Left Leg (Figure 5)
10
Turn the Face Plate Adjustment Knob clockwise to raise the Face Plate which draws more wire -
making the overall length of the stitch longer. If the overall length is too long, turn the Face Plate
Adjustment Knob counter-clockwise to lower the Face Plate and decrease the draw of wire pulled
from the Wire Spool. Once the correct length of wire has been achieved, tighten the Face Plate
Adjusting Lock Screw. As a rough gauge, the distance the Face Plate is above the Bonnet (2601R)
should be equal to the work thickness.
NOTE: If the Face Plate is adjusted too high (turning the Face Plate
Adjustment Knob too far clockwise) the Grip (9015) will lock in an open position
and draw no more wire. The MiniStitcher has a capacity of 1/4” and will allow no
more than that amount of wire to be drawn from the spool.
Adjusting the Stitch’s Left Leg
If after a few stitches, the length of
the stitch’s left leg is too short compared to
that of the right, you will need to adjust the
Wire Guide Spring Bracket (MG10001A).
Loosen the Wire Guide Spring Bracket Screw
(9075) found on the side of the Head. Turn the
Face Plate Adjustment Knob clockwise and
tighten the screw. If the length of the left leg
is too long, loosen the Wire Guide Spring
Bracket Screw and turn the Face Plate
Adjustment Knob counter-clockwise. After
the length of the stitch’s left leg is satisfactory,
make sure to tighten the screw again.
Figure 5 - Adjusting the Left Leg and Wire Draw
!
Do not operate the MiniStitcher Stitcher
until all guards are in place

CAUTION
!
9075
MG10013
9799
9046A
MG10001A
2601R
9015
9038M or
9038A