Delta DVP-10PM, Руководство по применению

Страница: 300 / 561

6
Motion Instructions and G-Code Instructions
DVP-PM Application Manual
6-19
X
Y
Z
Z= 0
X
Y
Z
Z= 0
C CW (Co unt erc lock wis e) C W (C lock wis e)
Ta rge t po in t
(x, y, z)
Ta rge t po in t
(x, y)
C en te r
C en te r
Sta rtin g p oi nt
Sta rtin g p oi nt
R ( radius)
R ( radius)
Ta rge t po in t
(x, y, z)
Ta rge t po in t
(x, y)
Z= 0
Sta rtin g p oi nt
Z= 0
Sta rtin g p oi nt
C en te r
C en te r R ( radius)
R ( radius)
8. The figure below illustrates the moving paths of the helical interpolation with and without the value on Y-axis.
(G18 mode, X-Z plane).
X
Y
Z
Y=0
Y=0
X
Y
Z
Y=0
Y=0
CCW (Counterclockwise)
CW (Clockwise)
Targ et p o in t
(x, y, z)
St arti ng
p o in t
Targ et p o in t
(x, z)
C en te r
C en te r
St arti ng
p o in t
R ( radius)
R ( radius)
Targ et p o in t
(x, y, z)
St arti ng
p o in t
St arti ng
p o in t
Ta rge t po in t
(x, z)
C en te r
C en te r
R ( radius)
R ( radius)
9. The figure below illustrates the moving paths of the helical interpolation with and without the value on X-axis.
(G19 mode, Y-Z plane)
X
Y
Z
X=0
X=0
X
Y
Z
X=0
X=0
CCW (Counterclockwise)
CW (Clockwise)
Targ et p o in t
(x, y, z)
C en te r
R ( radius)
R ( radius)
Sta rtin g
p oi nt
Sta rtin g
p oi nt
C en te r
Tar get
point
(y, z)
Targ et p o in t
(x, y, z)
C en te r
C en te r
Sta rtin g
p oi nt
Tar get poi nt
(y, z)
Sta rtin g
p oi nt
R ( radius)
R ( radius)
.
10. 16-bit devices and 32-bit devices can be used together.
11. Programming rule: (1) Target position and radius is a must while the moving speed is not; (2) If the coordinate of
X/Y/Z axis of target position is the same with that of current position, the same X/Y/Z value could be left out
12. If you set up the target position on the axis without setting up the moving speed, the operation will run at V
MAX