Dell S4820T, Руководство по настройке

Страница: 699 / 1178

When configuring the
network
command, configure a network address and mask that is a superset of
the IP subnet configured on the Layer-3 interface for OSPFv2 to use.
You can assign the area in the following step by a number or with an IP interface address.
• Enable OSPFv2 on an interface and assign a network address range to a specific OSPF area.
CONFIG-ROUTER-OSPF-id mode
network ip-address mask area area-id
The IP Address Format is A.B.C.D/M.
The area ID range is from 0 to 65535 or A.B.C.D/M.
Enable OSPFv2 on Interfaces
Enable and configure OSPFv2 on each interface (configure for Layer 3 protocol), and not shutdown.
You can also assign OSPFv2 to a Loopback interface as a virtual interface.
OSPF functions and features, such as MD5 Authentication, Grace Period, Authentication Wait Time, are
assigned on a per interface basis.
NOTE: If using features like MD5 Authentication, ensure all the neighboring routers are also
configured for MD5.
In the example below, an IP address is assigned to an interface and an OSPFv2 area is defined that
includes the IP address of a Layer 3 interface.
The first bold lines assign an IP address to a Layer 3 interface, and the
no shutdown
command ensures
that the interface is UP.
The second bold line assigns the IP address of an interface to an area.
Example of Enabling OSPFv2 and Assigning an Area to an Interface
Dell#(conf)#int te 4/14
Dell (conf-if-te-4/14)#ip address 10.10.10.10/24
Dell (conf-if-te-4/14)#no shutdown
Dell(conf-if-te-4/14)#ex
Dell(conf)#router ospf 1
Dell(conf-router_ospf-1)#network 1.2.3.4/24 area 0
Dell (conf-router_ospf-1)#network 10.10.10.10/24 area 1
Dell(conf-router_ospf-1)#network 20.20.20.20/24 area 2
Dell(conf-router_ospf-1)#
Dell#
Dell Networking recommends using the interface IP addresses for the OSPFv2 router ID for easier
management and troubleshooting.
To view the configuration, use the
show config
command in CONFIGURATION ROUTER OSPF mode.
OSPF, by default, sends hello packets out to all physical interfaces assigned an IP address that is a subset
of a network on which OSPF is enabled.
To view currently active interfaces and the areas assigned to them, use the
show ip ospf interface
command.
Open Shortest Path First (OSPFv2 and OSPFv3)
699