Dell S4820T, Руководство по настройке

Страница: 244 / 1178

Filtering BGP Routes Using Route Maps
To filter routes using a route map, use these commands.
1. Create a route map and assign it a name.
CONFIGURATION mode
route-map map-name [permit | deny] [ sequence-number ]
2. Create multiple route map filters with a match or set action.
CONFIG-ROUTE-MAP mode
{match | set}
For information about configuring route maps, refer to Access Control Lists (ACLs) .
3. Return to CONFIGURATION mode.
CONFIG-ROUTE-MAP mode
exit
4. Enter ROUTER BGP mode.
CONFIGURATION mode
router bgp as-number
5. Filter routes based on the criteria in the configured route map.
CONFIG-ROUTER-BGP mode
neighbor { ip-address | peer-group-name } route-map map-name {in | out}
Configure the following parameters:
•
ip-address
or
peer-group-name
: enter the neighbor’s IP address or the peer group’s name.
•
map-name
: enter the name of a configured route map.
•
in
: apply the route map to inbound routes.
•
out
: apply the route map to outbound routes.
To view the BGP configuration, use the
show config
command in CONFIGURATION ROUTER BGP
mode. To view a route map configuration, use the
show route-map
command in EXEC Privilege mode.
Filtering BGP Routes Using AS-PATH Information
To filter routes based on AS-PATH information, use these commands.
1. Create a AS-PATH ACL and assign it a name.
CONFIGURATION mode
ip as-path access-list as-path-name
2. Create a AS-PATH ACL filter with a deny or permit action.
AS-PATH ACL mode
{deny | permit} as-regular-expression
244
Border Gateway Protocol IPv4 (BGPv4)