Dell QLogic Family of Adapters, Руководство пользователя

Страница: 87 / 915

User Diagnostics for Windows NIC Driver Management Applications: QLogic QME8242 Mezzanine Card User's Guide
file:///T|/htdocs/NETWORK/QLogic/71922/en/diag_win.htm[9/26/2012 4:26:06 PM]
--LinkST
-nR
--noCRegs
No control registers test (combine –D or –a)
-nl
--noIRQS
No interrupt test (combine –D or –a)
-nL
--noIntLP
No internal loopback test (combine –D or –a)
-nH
--noHw
No hardware test (combine –D or –a)
-nS
--noLinkSt
No link status test (combine –D or –a)
-h
--help
View help text
For every test performed, the diagnostic utility shows the following data:
Total number of attempts
Number of successful completions
Number of failures
You can either perform all tests in succession, or perform only specific tests specified by the preceding command-line
parameters.
You can run additional diagnostics in the CLI as listed in the following table. To determine the cna_port_inst, issue the qaucli
-nic –i command as shown in Table 6 .
Table 6. Running Windows Diagnostic Tests in the CLI
Test Type Command
External Loopback qaucli -nic -extloopback <cna_port_inst> <tests_num> <on_error>
Where <tests_num> specifies the number of tests, 1–65535, and <on_error>> is either
0=Ignore or 1=Abort.
NOTE: This test requires a pass-through module to be configured for both ports. Test
runs between two ports. Single port loopback is not supported.
Flash qaucli –nic –testflash [cna_port_inst]
Hardware qaucli –nic –testhw [cna_port_inst]
Internal Loopback qaucli -nic -intloopback <cna_port_inst> <tests_num> <on_error>
Where <tests_num> specifies the number of tests, 1–65535, and <on_error>> is either
0=Ignore or 1=Abort.
Interrupt qaucli –nic –testinterrupt [cna_port_inst]
Link qaucli -nic -testlink [cna_port_inst]
Ping (IPv4) qaucli -nic -ping <cna_port_inst> <hostname_or_IPv4> [<count> <pocket_size>
<timeout_ms> <TTL>]
Where the default values are count=5, pocket_size=525, timeout_ms=1000, and
TTL=30.
Register qaucli -nic -testregister [cna_port_inst]
Transceiver DMI Data qaucli -nic -trans [cna_port_inst]
Windows Diagnostic Test Descriptions