Figure 51. Removing and installing the information tag
1.
information tag
2. tab (2)
3. slot
Next steps
1.
Install the control panel assembly.
2.
Follow the procedure listed in
After working inside your system
.
Related Tasks
Preparing a system for conversion from tower mode to rack mode
Removing the optional optical drive or tape drive
Installing the control panel assembly
Installing the optical drive or tape drive
Installing the control panel assembly
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Ensure that you follow the
Safety instructions
.
2.
Keep the Phillips #2 screwdriver ready.
Steps
1.
Replace the blank information tag in the new control panel with the information tag retained from
the old control panel.
NOTE: Information tag lists system information such as Service Tag, NIC, MAC address.
2.
To install the information tag, push the information tag into the control panel slot.
3.
Connect the control panel cable and the control panel USB cable to the control panel module.
122
Содержание poweredge t330
Страница 1: ...Dell PowerEdge T330 Owner s Manual Regulatory Model E35S Series Regulatory Type E35S001 ...
Страница 104: ...Figure 40 Opening and closing the processor shield 1 processor shield 2 tab on the processor shield 3 socket lever 104 ...
Страница 132: ...Figure 56 Removing and installing the screws on the system board 1 screw 8 132 ...
