2.
Follow the procedure listed in
Before working inside your system
.
3.
Remove the cooling shroud.
Steps
1.
Hold the cooling fan by the sides with the cable end facing the bottom of the chassis.
CAUTION: Do not remove or install the internal cooling fan by holding the fan blades.
2.
Align the four tabs on the internal cooling fan with the four slots on the chassis wall.
3.
Press and slide the internal cooling fan into the slots until the release tab locks into place.
4.
Connect the internal cooling fan power cable to the FAN6 connector on the system board.
Next steps
1.
Install the cooling shroud.
2.
Follow the procedure listed in
After working inside your system
.
Related Tasks
Removing the cooling shroud
Installing the cooling shroud
Internal USB memory key (optional)
A USB memory key installed inside your system can be used as a boot device, security key, or mass
storage device. The USB connector must be enabled by the
Internal USB Port
option in the
Integrated
Devices
screen of System Setup.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify
the USB memory key in the boot sequence in System Setup.
NOTE: To locate the internal USB connector (INT_USB) on the system board, see
System board
jumpers and connectors
.
Replacing the optional internal USB memory key
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Ensure that you follow the
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
Steps
1.
Locate the USB connector or USB memory key on the system board.
NOTE: To locate the internal USB connector on the system board, see
System board jumpers
and connectors
.
2.
If installed, remove the USB memory key from the USB connector.
3.
Insert the replacement USB memory key into the USB connector.
89
Содержание poweredge t330
Страница 1: ...Dell PowerEdge T330 Owner s Manual Regulatory Model E35S Series Regulatory Type E35S001 ...
Страница 104: ...Figure 40 Opening and closing the processor shield 1 processor shield 2 tab on the processor shield 3 socket lever 104 ...
Страница 132: ...Figure 56 Removing and installing the screws on the system board 1 screw 8 132 ...
