1.
.
2.
Follow the procedure listed in
Before working inside your system
3.
Disconnect any cables connected to the expansion card.
4.
Remove the expansion card riser out of the server.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full
length card.
Steps
1.
For expansion cards:
a. Installed in PCIe slots 3 and 4 of the dual riser module, lift the expansion card lock up.
b. Installed in PCIe slots 1 and 2 of the dual riser module, pull the expansion card lock down and
away from the dual riser module.
2.
Pull the expansion card away from the riser.
3.
If you want to remove the expansion card permanently, install a metal filler bracket over the empty
expansion slot opening and close the expansion card latch.
4.
Close the expansion card lock.
NOTE: You must install a filler bracket over an empty expansion slot to maintain Federal
Communications Commission (FCC) certification of the system. The brackets also keep dust
and dirt out of the system and aid in proper cooling and airflow inside the system.
Figure 32. Removing and installing a low profile expansion card from the dual riser module
1.
low profile expansion card
2. expansion card retention latch
3. dual riser module
90
Содержание PowerEdge R530xd
Страница 1: ...Dell PowerEdge R530xd Owner s Manual Regulatory Model E29S Series Regulatory Type E29S002 ...
Страница 163: ...163 ...
