Dell PowerEdge M IO Aggregator, Справочное руководство

Страница: 16 / 264

14 | CLI Basics
www.dell.com | support.dell.com
Multiple Configuration Users
When a user enters CONFIGURATION mode and another user(s) is already in that configuration
mode, FTOS generates an alert warning message similar to
Figure 3-2 :
Figure 3-2. Configuration Mode User Alert
When another user enters CONFIGURATION mode, FTOS sends a message similar to the following,
(the user in this case is “admin” on vty2):
% Warning: User “admin” on line vty2 “172.16.1.210” is in configuration
Navigating the Command Line Interface
The command line interface (CLI) prompt displayed by FTOS is comprised of:
• “hostname”— the initial part of the prompt, “FTOS” by default. You can change it with the
hostname command, as described in hostname .
• The second part of the prompt, reflecting the current CLI mode, is shown in Table 3-1 .
The CLI prompt changes as you move up and down the levels of the command structure.
Table 3-1 lists the prompts and their corresponding command levels, called modes . Starting with
CONFIGURATION mode, the command prompt adds modifiers to further identify the mode. The
command modes are explained in
Command Modes .
FTOS#conf
% Warning: The following users are currently configuring the system:
User "" on line console0
User "admin" on line vty0 ( 123.12.1.123 )
User "admin" on line vty1 ( 123.12.1.123 )
User "Irene" on line vty3 ( 123.12.1.321 )
FTOS#conf
Table 3-1. Command Prompt and Corresponding Command Mode
Prompt CLI Command Mode
FTOS> EXEC
FTOS# EXEC Privilege
FTOS(conf)# CONFIGURATION
FTOS(conf-if-te-0/0)#
FTOS(conf-if-vl-1)#
FTOS(conf-if-ma-0/0)#
FTOS(conf-if-range)#
INTERFACE
FTOS(conf-line-console)#
FTOS(conf-line-vty)#
LINE
FTOS(conf-mon-sess)# MONITOR SESSION