15.
Rotate the release lever back down until it snaps into place, securing the processor cover.
16.
Install the heat sink.
a.
Using a clean lint-free cloth, remove the existing thermal grease from the heat sink.
b.
Apply thermal grease evenly to the top of the processor.
c.
Place the heat sink onto the processor. See
Figure 5
-9
.
d.
Using a #2 Phillips screwdriver, tighten in a diagonal pattern the four captive screws that secure the heat sink to the system board. See
Figure 5
-
9
.
17.
Install the cooling shroud. See "
Installing the Cooling Shroud
."
18.
Close the system. See "
Closing the System
" in "Troubleshooting Your System."
As the system boots, it detects the presence of the new processor and automatically changes the system configuration information in the System Setup
program.
19.
Press <F2> to enter the System Setup program, and check that the processor information
matches the new system configuration.
See your
User's Guide
for instructions about using the System Setup program.
20.
Run the system diagnostics to verify that the new processor operates correctly.
See "
Running the System Diagnostics
" for information about running the diagnostics and troubleshooting processor problems.
Back to Contents Page
NOTE:
Use the heat sink that you removed earlier in this procedure.
Содержание PowerEdge 850
Страница 90: ......
Страница 132: ...Back to Contents Page ...
Страница 137: ...17 Close the system See Closing the System in Troubleshooting Your System Back to Contents Page ...
