No.
Indicator
Status
Blinking blue (2 Hz): Enclosure management is busy
Constant amber: module fault present
Blinking amber: logical fault (2 s on, 1 s off)
3
Unit identification display
Green (seven-segment display: enclosure sequence)
4
Identity
Blinking blue (0.25 Hz): system ID locator is activated
Off: Normal state
System power LED (green)
LED displays green when system power is available. LED is off when system is not operating.
Status/Health LED (blue/amber)
LED illuminates constant blue when the system is powered on and functioning normally. The LED blinks blue when enclosure management
is busy, for example, when booting or performing a firmware update. The LEDs help you identify which component is causing the fault.
LED illuminates constant amber when experiencing a system hardware fault which could be associated with a Fault LED on a controller
module, IOM, or PCM. LED illuminates blinking amber when experiencing a logical fault.
Unit identification display (green)
The UID is a dual seven-segment display that shows the numerical position of the enclosure in the cabling sequence. The UID is also called
the enclosure ID.
NOTE:
The controller enclosure ID is 0.
Identity LED (blue)
When activated, the Identity LED blinks at a rate of 1 second on, 1 second off to locate the chassis within a data center. The locate
function can be enabled or disabled through SES. Pressing the button changes the state of the LED.
NOTE:
The enclosure ID cannot be set using the Identity button.
5U enclosure Ops panel
The front of the enclosure has an Ops panel that is located on the left ear flange of the 5U chassis.
The Ops panel is part of the enclosure chassis, but is not replaceable on-site.
The Ops panel provides the functions that are shown in the following figure and listed in
Table 10. Ops panel functions – 5U enclosure
Figure 31. Ops panel LEDs—5U enclosure front panel
60
Troubleshooting and problem solving
