DELAIR UX5 HP, Руководство пользователя

Страница: 74 / 137

4. Using first the wet camera wipes and then the dry camera wipes, thoroughly clean the camera lens.
Make sure there are no specks of moisture or dust, as these will affect the image quality.
Note – Only use wipes that are specifically intended for cleaning camera lenses.
5. Make sure the camera filter in the rover body is also clean and that the camera filter is tightly screwed
into the body. If not, gently tighten it, taking care not to over-tighten it.
The camera filter is not prefitted into the UX5 HP body when you receive the system. You must insert
the camera filter before using the system for the first time. To do this, click
in the Home screen,
select Camera / UX5 HP and then select Adapting the payload bay or refer to the UX5 HP Aerial
Imaging Solution Maintenance Guide .
Note – Using the incorrect filter will affect the quality of images captured during flight. Make sure you
are using the correct filter for your camera, as detailed below:
Camera type Filter type
Sony a7R RGB camera UX5 HP UV filter, 77 mm, Tiffen
Sony a7R NIR camera UX5 HP yellow-orange filter, 77 mm, Schneider Kreuznach
Inserting the camera
Insert the camera into the camera cavity of the payload bay. Connect the hot shoe cable in the rover to the
hot shoe of the camera. Secure the camera using the Velcro straps.
For more information, see
Inserting the camera, page 66 .
Note – After inserting and securing the camera, check the shutter speed and the exposure compensation
dial (which should be set to 0) as the settings control might have spun and changed the setting.
Checking the camera trigger and shutter feedback
In the Aerial Imaging software, tap . Make sure that you hear the trigger sound from the camera and
observe one red LED flash from the gBox.
When the checks are successful, the button is enabled.
Inserting the tracker transmitter
1. Turn on the tracker transmitter.
2. Make sure that you can hear the transmitter using the tracker receiver.
3. Insert the tracker transmitter into the body of the rover.
Closing the payload bay
Make sure the payload is secured with the Velcro strap. Attach the top cover to the payload bay and make
sure it is secure.
Covering the pitot tube
Put the pitot tube cover on the pitot tube.
74
Delair-Tech | 676, Rue Max Planck – 31670 Toulouse-Labège, France | Tel: +33 (0) 5 82 95 44 06 | www.delair.aero
Capital: 238 110,30 € - APE: 3030Z – Intra-Community VAT number: FR90 53 09 69 781 – 530 969 781 R.C.S. Toulouse
This document is the sole property of Delair-Tech and cannot be used or reproduced without the written authorization of Delair-Tech .