264
265
Assembly Guide
264
265
7
8
9
At the other three cable tie positions
(outlined in red, above), use the cable ties
to secure the feeder motor cable and the
spiral tube to the housing. When you’ve
done up each cable tie, trim off the excess
with scissors.
Pass the feeder motor cable through
the hole in the casing to the left of the
noise filter.
Turn the housing so the front is facing you.
Untwist the feeder motor cable you’ve just
passed into the housing (if necessary) and
plug the connector into the pins (outlined
in yellow, above) on the motor board for
the feeder motor cable.
The Z-axis motor and feeder motor
drivers have been fitted to the driver
board and the feeder cable has
been plugged into the driver board.
There are two different connectors
on the USB cable supplied this
time. The smaller, squarer one is
the B-type and is plugged into the idbox.
The wider, flatter one is the A-type, and this
is plugged into the USB port on a computer.
Check the power supply from a computer to the circuit board
10
12
11
With the right side of the printer facing you,
plug the B-type connector of the USB cable
into the USB port on the circuit board.
The circuit board is powered
via the USB cable by your computer.
When you connect the USB cable
to your computer you should see a
green light come on on the circuit
board (lower photo). Check this, then
remove the USB cable and keep it
safe.
With your computer turned on, plug the
A-type USB connector into a USB port on
the computer.
Plug in
Plug in
USB
symbol
B type
B type
A type
A type
Stage
finished
