266
267
Assembly Guide
266
267
The power supply has no fewer than
nine terminals to which you attach cables
in this stage. After wiring up the power
supply, you attach it to the inside of the
base of the housing and connect it to the
thick power cables, the fan cables and
the noise filter. Make sure you follow the
instructions carefully and be sure to check
over your assembly so you can be certain
that the cables are all connected properly.
This is extremely important, as if the
cables are not correctly wired up, there is
a real danger that the printer will fail when
the power is switched on.
Parts to have ready
Set the input voltage to 230V (for UK)
1
The printer housing.
1:
Power supply x 1
2:
Power lines x 2
3:
Earth wire x 1
4:
Power supply wires for the fans x 2
5:
M3 truss head screws x 4
Stage 42 Components
In this stage, you will wire up the power supply, then attach it to the housing. After that,
connect up more of the wiring inside the housing. It is vital to get the wires connected
properly, so take care as you do it.
You will need
Phillips screwdriver size 1
Phillips screwdriver size 2
Stage 42: Connect up the power
supply and fix it to the housing
Stage 42 Assembly Area
1
2
3
4
5
2
There is a switch on the side of the power supply
where you can select the input voltage from the
mains to the power supply. For the UK, make sure
it is switched to 230V and not 115V.
Incorrect
