278
279
Assembly Guide
278
279
2
3
4
Attach the linear bush to the table base
Screw holes
Hole for linear
bush
Dog
With the dog at the top left, locate the circular
hole surrounded by four screw holes at the top
left of the table base where the second linear
bush is to be added.
5
5
6
After you’ve put the washers onto each bolt,
screw an M3 nut onto each of the four bolts
with your fingers.
Turn the table and, holding each of the nuts with your
fingers, tighten the cap head bolts in turn with the 50
x 2.5mm Allen key.
Put the shaft of the bush through
the hole and put a 15mm M3 cap
bolt through each of the screw holes
(ringed in red) in the bush.
Hold the bolts in position and turn the
table over. Put an M3 flat washer and
then an M3 spring washer over the
shafts of each of the bolts.
The second linear bush has been added to the table. Put the
table somewhere safe until it is time to add it to the housing.
7
Because it is difficult to adjust the dog after the table has
been assembled into the housing, now is the time to check
its alignment. Ensure that the underside is aligned with the
table (as shown above) and tighten the screw to secure it
in position.
Adjust the position of the dog
Underside
aligned
with table
Levels are different
Stage
finished
4
