268
269
Assembly Guide
268
269
17
18
Hold the power supply in position with one hand so that the four screw holes in its
underside align with the screw holes in the bottom panel (ringed in red). Insert an 8mm
M3 truss head screw into each of the screw holes and screw them in with your fingers.
Plug the connector of the green Earth wire
onto the central, upper metal pin on the
noise filter.
Tuck the four thick power cables (two black, two pink) into the bottom of the housing, as
shown above left and above right. If you unplug any of the connectors from the driver
board while you do this, make sure you get them back into the correct locations.
Tighten all four of the screws with a size 1
Phillips screwdriver.
When tidying the thick power
cables to the bottom of the
housing, unplug the motor cables
one at a time and plug them back in as
soon as you can to avoid mixing them up.
Connect the remaining cables
16
Turn the housing so its base is back on your work surface. Plug the two yellow power
supply lines as shown above onto the two lower terminals of the noise filter, which is at
the rear left of the housing. Push them all the way on, firmly yet gently.
The noise filter has
three metal pins. Of these,
two are side by side and have
a black cover to their bases.
These are the pins for the
power lines. The other pin is for
the Earth wire. Make sure you
plug the correct wires onto the
correct pins.
Earth
wire
Power
lines
14
15
Plug on
Plug on
