Start Here
2
Press the power button to turn on the product, then
wait for the power light to stop flashing. The power
light and the ink light stay on.
3
Press and hold the stop button for
5 seconds until the
power light starts to flash and ink charging begins.
Note:
Ink charging takes about 10 minutes. When the power
light stops flashing, ink charging is complete.
Caution:
Do not turn off the product, open the front cover, or
load paper while the product is charging or you’ll waste ink.
4
Load paper
See the online User’s Guide for information about loading
capacity and available paper types and sizes.
1
Make sure the product is not charging ink. Then raise the
paper support and tilt it backwards slightly.
IMPORTANT: Before using this product, make sure you read
these instructions and the safety instructions in the online
User’s Guide.
1
Unpack
Note:
Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability.
Remove all protective materials from the product.
Note:
Do not turn on the product yet.
2
Fill ink tanks
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
Caution:
•
This product requires careful handling of ink. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink
gets on your clothes or belongings, it may not come off.
• Epson cannot guarantee the quality or reliability of non-genuine ink.
The use of non-genuine ink may cause damage that is not covered
by Epson’s warranty.
Note:
Use the ink bottles included with the printer to set up the
product. Part of the ink will be used to charge the print head. These
bottles may print fewer pages compared with subsequent ink bottles.
1
Open the ink tank cover and the cap for the black ink
tank.
Note:
Refer to the color-coded sticker on the ink tank unit to
identify the color of each tank.
2
Unpack the black (BK) ink bottle. Hold the ink bottle
upright and slowly turn the bottle cap to remove it.
Caution:
Do not shake or squeeze the ink bottles. Do not touch
the top of the ink bottle after its cap is removed.
3
Place the top of the ink bottle on the filling port, then
slowly stand the bottle upright to insert it, as shown.
Note:
Do not force the bottles into position; they are keyed for
each color.
4
Wait for the ink to fill the tank.
Do not squeeze the bottle.
Note:
Ink flows into the tank and stops automatically when the
ink tank is filled to the upper line. If ink does not flow from the
bottle, lift and reinsert the bottle.
5
When the ink tank is full, remove the ink bottle and
securely close it with the bottle cap.
Note:
Do not leave the ink bottle inserted; otherwise the bottle
may be damaged or ink may leak. If any ink remains in the bottle,
store the bottle upright for later use.
6
Close the black ink tank cap.
7
Repeat the previous steps for the other colors.
8
Close the ink tank cover.
3
Turn on and charge the ink
1
Connect the power cord to the back of the product and to
an electrical outlet.
Caution:
Do not connect to your computer yet.
L1110
4136912 Rev.0
1-F
C
4136912 Rev.0
1-F
M
4136912 Rev.0
1-F
Y
4136912 Rev.0
1-F
K
