DATREND Systems Oxitest Plus 7, Руководство по эксплуатации

Страница: 22 / 62

OXITEST PLUS 7 OPERATING MANUAL
The menu of oximeters provides up to 128 entries. The Pulse Amp
•
or
–
keys will single-step
through the menu sequentially, moving up or down respectively. To move more rapidly through the
different menu selections, the
Heart Rate
•
or
–
keys will move in steps of two entries at a time.
The previous display indicates if the oximeter is currently ENA bled or DIS abled. Press the Pulse
Ox key to toggle the ENA bled or DIS abled status of the displayed oximeter.
When only the relevant oximeters are ENA bled, press the SpO
2
key, and Oxitest Plus 7 will revert
to normal operation. The only oximeters that will now be available for selection in the menu of
Pulse Ox’s will be those that have been ENA bled. This process may be repeated at any time to
ENA ble or DIS able other oximeters.
In the event of a loss of battery power, Oxitest Plus 7 will revert to the factory default settings (all
oximeters ENABLED; Pulse Ox = Nellcor N-200; SpO
2
= 97%; Heart Rate = 60 BPM; Pulse Amp
= 100%).
If it is desirable to reset
Oxitest Plus 7
to the factory default settings for any reason, hold down the
Heart Rate preset key while powering up the unit. The display will appear as shown below. In
response to the LCD prompt, the factory defaults are loaded by pressing the YES (Pass) key or the
No (Fail) key.
Load default setup?
YES (
•
) or NO (
–
)
3.3 Setting Display Contrast
Display contrast for Oxitest Plus 7 is pre-set at the factory. Should it become necessary to adjust
the display contrast, the adjustment control is located in the probe storage compartment (refer to
Figure 4 ).
Oxitest Plus 7
must be powered ON (finger probe extended) in order to access this
adjustment.
Figure 4
Operation/Chapter 3
#
Page 12