DT4120 xx xx (PS)
16
20170324-V0
5.4. Connecting the limit relay outputs (option).
The following figure shows the wiring plan, connecting the
limit relay outputs:
Wiring plan, connecting
the limit relay outputs
(see also “Application
example”)
The push-in direct connector assemblies used allow a fast
connection of the cables.
Follow the next steps:
1. Push the stripped cable-end until it possible into the
terminal assembly. In the case of flexible cable-ends, you
can facilitate opening the connection part by pushing down
the white button.
2. By pushing the wire in, the self-closing connection is
being established. Check it by pulling it outwards firmly.
(3. When you are going to disassemble the cable, push
down the white button by a screwdriver, and pull the cable-
end out.)
The button can be pushed down easily. Please do not
exercise forces higher than necessary, as it may cause
damages to the terminal assembly.
Содержание DT4120 Series
