Datcon DT4120 Series, Руководство по эксплуатации

Страница: 57 / 92

DT4120 xx xx (PS)
20170324-V0
57
7.15. Analoge output signal setting (14. menu item)
Function In this menu item you can choose between 4-20 mA and
0-20 mA output current. [Factory default: 4-20 mA]
Sequence of operations 1. Enter the menu by typing a supervisor code.
The way the code should be type is described in Chapter
7.1. Typing the code in. You see on the display:

.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:

( Ana log = analog).
3. Enter the menu item by pressing the ENTER button.
4. You see this:

on the display The text is
blinking, signaling that it can be modify
5. Pressing
▲ button you can choose between the two
output signal:
•


: 4-20 mA current output [Factory default]
•


: 0-20 mA current output.
Exit from the menu item 1. After you have performed the setting, press the MENU
button. This takes you out from the menu item, and you see
this:

.
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 3 of the
Sequence of
operations .)
(3. If you do not want to exit from the menu because you
want to perform other settings too, you may press the
▲
button to select the desired menu item.)
Exit from the menu
Press the MENU button. First the mnemonic

( Save ),
then the mnemonic

( Exit ) are shown on the display.
With this the storing of the settings is completed. The
instrument has exited the menu and goes on with the
measurement