Datcon DT4120 Series, Руководство по эксплуатации

Страница: 78 / 92

DT4120 xx xx (PS)
78
20170324-V0
9. Dismounting
9.1. Dismounting procedure
Before dismounting take note the warnings written in
Chapter
5.1.
The following figure shows the dismounting procedures:
Dismounting
The dismounting procedure needs a screwdriver for slotted
screws.
Before put off power supply and disconnect all wires.
1. Slip the tip of the screwdriver into the hole of the
mounting clamp (A) (Figure step 1).
2. Move the screwdriver handle to make free the clamp
(Figure step 2).
3. Keeping the screwdriver in this position draw back the
mounting clamp (Figure step 3).
Please do not exercise forces higher than necessary, as it
may cause damages to the clamp.
4. Repeat the 1., 2., 3. steps with the other clamp.
5. You can take out the instrument from the panel cutout.