Trigger Mode
Auto, Triggered or
Single
Configures the trigger mode.
Default is Auto.
Action required:
Press Trigger Mode to select a trigger mode.
Auto
Configures the scope to display a single-sweep meas-
urement when a trigger is received, or automatically if a trig-
ger is not received. The scope continues running and waits
for another trigger when the measurement completes.
Triggered
Configures the scope to display a single-sweep
measurement when a trigger is received. The scope stops
running when the measurement completes.
Single
Configures the scope to display a single-sweep
measurement when a trigger is received. The scope
continues running and waits for the next trigger when the
measurement completes.
Slope
Pos or Neg
Configures the trigger slope.
Default is Positive.
Action required:
Press Slope to toggle between Pos and Neg.
Pos (Positive)
The measurement will be triggered on the positive (up-slope)
portion of the waveform.
Neg (Negative)
The measurement will be triggered on the negative (down-
slope) portion of the waveform.
Marker
-
Select measurements to be displayed at the bottom of Marker view.
Scope marker properties
Press Properties > Marker to access the scope marker properties.
Use the navigation keys to select the measurements that appear on the bottom of the display in Marker view.
Measurements apply to the portion of the waveform between the two markers. You can only select a maximum of
three measurements to be displayed.
140
Keysight E36150 Series User's Guide
