Viper User
Manual (001-5008-000 Rev6)
Page
33
STEP 3:
Verify FCC license before completing this step.
Channel ID: Enter 1 for Channel ID
Channel Type: Select Channel Type
RX Frequency: Enter RX Frequency
TX Frequency: Enter TX Frequency
TX Power: Enter 5 W
Set Active Channel: Select Yes
Click “Apply” Click “Next”
Figure 3.9 Using the Setup Wizard: Step 3
STEP 4:
The Viper uses AES-128 bit encryption to protect your data from
intrusion. Use of encryption is optional but we strongly recommend
it for network configuration. The encryption phrase/key must be common
to all units in a network.
Encryption Disabled
Encryption: Click Disabled
Click “Apply”. Click “Next”.
Encryption Enabled
Encryption: Click Enabled
Encryption Pass Phrase: Enter an encryption phrase
Note this phrase for reference later
Click “Apply”. Click “Next”.