DKG-507 User Manual V-42
(24.05.2013)
- 12 -
The unit offers the possibility of
REMOTE START
mode of operation. The
SPARE-2
input may
be assigned as
Remote Start Input
using the program parameter
P_083
.
The REMOTE START signal may be a NO or NC contact, switching to either battery positive or
battery negative. These selections are made using programming menu.
It is also necessary to set the
ACTION
program parameter of the
SPARE-2
input to
3
in order to
prevent any alarm from this input.
In this mode the mains phases are not monitored. If the REMOTE START signal is present
then the mains will be supposed to fail, inversely if the REMOTE START signal is absent, then mains
voltages will be supposed to be present. The front panels mimic
diagram’s mains LEDs will reflect the
status of the REMOTE START input.
The unit has the ability to adapt to any type of oil pressure and temperature senders. The
commonly used standard sender characteristics are recorded in memory and selectable from a list.
However non standard senders may also be used by entering their characteristics to the table.
Oil Pressure Sender Type Selection:
Selectable sender types are:
0:
Sender characteristics are defined in
Sender Characteristics
table.
1:
VDO 0-7 bars (10-180 ohms)
2:
VDO 0-10 bars (10-180 ohms)
3:
DATCON 0-7 bars (240-33 ohms)
4:
DATCON 0-10 bars (240-33 ohms)
5:
DATCON 0-7 bars (0-90 ohms)
6:
DATCON 0-10 bars (0-90 ohms)
7:
DATCON 0-7 bars (75-10 ohms)
Temperature Sender Selection:
Selectable sender types are:
0:
Sender characteristics are defined in
Sender Characteristics
table.
1:
VDO
2:
DATCON DAH type
3:
DATCON DAL type
Fuel Level Sender Selection:
The
Fuel Level Sender
characteristic is programmable through table.
Oil Temperature Sender Selection:
Selectable sender types are:
0:
Sender characteristics are defined in
Sender Characteristics
table.
1:
VDO
2:
DATCON DAH type
3:
DATCON DAL type
6.2 Sender type Selection
6.1 Remote Start Operation
6. OTHER FEATURES
