DM-
SV01 Server ● BMC User Manual ● Rev. 2.1
18
DIMM 5
Information about DDR memory installed at socket P0, slot F
DIMM 6
Information about DDR memory installed at socket P0, slot G
DIMM 7
Information about DDR memory installed at socket P0, slot H
DIMM 8
Information about DDR memory installed at socket P1, slot A
DIMM 9
Information about DDR memory installed at socket P1, slot B
DIMM 10
Information about DDR memory installed at socket P1, slot C
DIMM 11
Information about DDR memory installed at socket P1, slot D
DIMM 12
Information about DDR memory installed at socket P1, slot E
DIMM 13
Information about DDR memory installed at socket P1, slot F
DIMM 14
Information about DDR memory installed at socket P1, slot G
DIMM 15
Information about DDR memory installed at socket P1, slot H
Table 1: DIMMs mapping on Hardware status menu
Important:
some system components are detected by BIOS/UEFI only during the system boot process,
when the information is then sent to the BMC through IPMI. Therefore, some system components may
not appear in the “Hardware status” menu or may be outdated if the system was not yet initialized.
Please perform a power on in the host CPUs (please check the section “2.3.1 Server power operations”)
and wait for the boot process to complete to make sure the information available in this menu is properly
updated.
2.2.3 Sensors
The DM-SV01 server has a set of sensors which are responsible for monitoring the voltage, current and
temperature at several relevant spots of the system. The sensors information is used for controlling the
FANs speed and generating alarms or emergency shutdown in case of reaching a critical threshold.
The Figure 16
below shows the “Sensors” screen available at the BMC web management interface.
Figure 16: BMC Sensors menu
