Dascom Tally DP-550, Руководство пользователя

Страница: 8 / 73

Printer Operation
Figure 1 - Printer Features
Battery Installation and Charging
Please refer to Figure 2 and insert the battery by sliding it into the battery compartment until the release lever on
the battery “snaps” into place.
Release Lever
Power Connector
Battery Indicator
Figure 2 - Battery Installation and Power Connector
The printer contains battery monitoring and charging circuitry so that the battery may be charged in the printer
using an optional power adapter. Dascom offers a variety of optional power adapters for use with 100-
240VAC/50-60Hz and 12/24VDC for vehicle applications.
Caution
: Use only Dascom power adapters designed specifically for your DP-550 printer. Using a different
power adapter may cause damage to the printer and will not be covered by the printer’s warranty.
Connect a power adapter to the appropriate input source, and then connect the output of the power adapter to the
printer’s Power Connector. The Battery Indicator will turn on and remain on until the battery is fully charged.
This may take up to 2½ hours. The Battery Indicator will turn off when the battery is fully charged and will
flash whenever the battery needs recharging.
Note
: New batteries are shipped in an “uncharged” state. The battery must be fully charged prior to first
operating the printer on battery power alone. The printer may be used while charging, but this may
cause the battery to take longer to reach a full charge. Maximum battery capacity is not reached until
after completing a minimum of three complete charge and discharge cycles.
When the power adapter is connected, the printer’s charging circuitry will determine if the battery currently
requires charging and if so, will turn on the Battery Indicator until the battery has reached sufficient charge.
Depending on the condition of the battery, charging may take up to 2½ hours to complete.
2