Auto
on
Reset
Hand
on
Off
Status
Quick
Menu
Main
Menu
Alarm
Log
Back
Canc
el
In
fo
OK
Status
1(0)
1234rpm
10,4A
43,5Hz
Run OK
43,5Hz
On
Alarm
Warn.
130BA018.13
1
2
3
4
b
a
c
Illustration 2.1 LCP
2.2.3 Display Area
a.
The top line shows controller status when in
status mode or two variables selected in
0-10 Active Set-up
, such as direction of rotation or
active set-up
b.
The motor values displayed are selected by
parameter choices in
0-20 Display Line 1.1 Small
,
0-21 Display Line 1.2 Small
,
0-22 Display Line 1.3
Small
,
0-23 Display Line 2 Large
, and
0-24 Display
Line 3 Large
. Each value has dimension scaling. A
flashing alarm or warning message replaces the
display in the case of a fault or pending fault
condition.
The operating variables shown in the figure are
motor speed (1.1), motor current (1.2), motor
power (1.3), and drive output frequency (2) in
large scale. Use the [INFO] key for definition of
the displayed operating variables.
c.
Automatically generated mode and status
messages appear on this line.
1.1
1.2
2
1.3
130BP062.10
207RPM
Auto Remote Running
1 (1)
24.4 kW
5.25A
6.9
Hz
Status
Illustration 2.2 LCP Display Area
2.2.4 Menu Keys
Menu keys are used for parameter set-up, toggling
through status display modes during normal operation,
and viewing fault log data.
130BP045.10
Status
Quick
Menu
Main
Menu
Alarm
Log
Status Press and hold the Status key to toggle between
status read-out displays in the LCP display area. Press
[Status] in any other display mode to return to the status
display. Pressing [Status] plus [UP] or [DOWN] arrows
adjusts the display brightness.
Quick Menu Allows access to the most common functions
for initialising the controller.
Main Menu Provides access to all programming
parameters. Press and hold the [Main Menu] key to access
any parameter by entering the parameter number.
Alarm Log Displays a list of the last five alarms. For
additional details about an alarm, select the alarm number
using the arrow keys and press [OK]. Details about the
frequency converter before it entered the alarm mode are
displayed.
2.2.5 Navigation Keys
Navigation keys are used for programming functions,
moving the display cursor, and speed control in local
controller operation. Controller status indicator lights are
also located in this area.
Operator Interface and Cont...
High Power Service Manual for Modular F Frame Drives
MG90K202 - VLT
®
is a registered Danfoss trademark
37
2
2
