© Danfoss 05-2011
AK-EM 100 Installation Guide
20
RC8BX402
site access via a modem on Serial Port 2.
If the Serial Port 2 has not been configured, the access to the modem settings will not be accessible. The
installation of the modem must be set up previously to access the settings page. Normally, the image
which is copied across to the AK-EM 100 when it is being installed will contain the IP settings and user
name and password.
1. The number of rings, Local and Remote IP addresses should already be populated, so simply enter
the User Name and Password e.g. Admin and AK-EM 100 respectively, the IP addresses and check the
Enable box.
2. Press the ‘Apply’ button to store the settings.
3. Connect to the modem by opening a VPN connection.
4. On the login box, click on the ‘Properties’ button and type in the phone number of the receiving
modem you are connecting to in the General tab (see next page).
5. Once a connection has been made and you are dialled into the modem, open a new browser and
type in the Local IP address (IP address of the AK-EM 100’s modem).
2.7 Modem Settings