DAITEM SH101AX, Руководство по установке

Страница: 13 / 50

223
GB
3.4 Wireless receiver alarm level parameter setting
The factory default setting for the infra red receiver, with radio , is “deterrence” (for system capabilities refer to the Installation guide
accompanying your control panel).
NOTE: if you wish an Intrusion alarm to be signalled by the control panel programme parameter 5 to value “1”, see table below.
It is possible to change the alarm level setting using the following sequence:
Parameter No. Value of parameter Alarm management Alarm level
5 1 yes intrusion
2 yes prealert
3 (factory default) yes deterrence
4 yes warning
Programming sequence
Programming
LED unlit
Programming
LED lit
Pressing
sequence
approx.
5 s. approx. 10 s. approx. 2 s. approx. 10 sec
Begin
the sequence
by pressing
& holding until the
LED extinguishes
5 successive
presses
corresponding
to the parameter
number
Press & hold
until LED
extinguishes
1 to 4 presses
corresponding to the desired
parameter value
End
the sequence
by pressing
& holding until the
LED extinguishes
LED remains
ON =
parameter
correctly
programmed
{
Begin 5 presses to select
parameter 5,
“Alarm level”
Press & hold
until LED
extinguishes
2 presses
to select value 2,
“Prealert” alarm level
End
Programming example: programming the infra red receiver module with an alarm level “Prealert”: parameter No. 5, parameter value 2.
5 2
2 s. env.
SH100AX A1
131A05789
SH100AX A1
131A05789
SH100AX A1
131A05789
SH100AX A1
131A05789
SH100AX A1
131A05789
SH100AX A1
131A05789
SH100AX A1
131A05789
SH100AX A1
131A05789
SH100AX A1
131A05789
SH100AX A1
131A05789
{