DAITEM SH101AX, Руководство по установке

Страница: 12 / 50

222
GB
3.3 Voice identification message recording
x
In order to easily identify the beams and their columns it is possible to record individual vocal messages of 3 seconds duration at the
control panel for each of the radio transmitters and so identify the single barrier beam or stacked/chained beam. A table is available at
the end of the manual to in order to note the messages and the position of their respective beams or columns.
• With a control panel fitted with software version 2.0.0 and later
(to know which software version you have, use the control panel keypad to check it by entering : # 5 0 3 # #)
- To record the message:
- Example of individual message: “detector 4, beam 1, receiver column” , dial:
To verify the identification message, dial:
“record the message” “playing recorded message”
“detector 4, beam 1, receiver column” “detector 4, beam 1, receiver column”
• With a control panel fitted with a software version below to 2.0.0
- To record the message:
- Example of individual message: “detector 4, beam 1, receiver column” , dial:
To verify the identification message, dial:
Q
6 6
Q
“record the message”
“playing recorded message” Q
Q
6 6
Q
0 4 Q
Q 6 6 Q 0 4 Q Q Q
“detector 4, beam 1, receiver column” “detector 4, beam 1, receiver column”
speak into the
microphone No. of detector from 01 to 80
(depending on the model of the
control panel & its max number of zones)
wait for the LED to light
before speaking the message
into the microphone
speak into the
microphone No. of detector from 01 to 80
(depending on the model of the control
panel & its max number of zones)
wait for the LED to light
before speaking the message
into the microphone
“detector 4, beam 1,
receiver column”
x
“detector 4, beam 1,
receiver column”