Daihen OTC ARXIS pulse P403L, Руководство пользователя

Страница: 155 / 188

C
ALIBRATION
M
ODE
A
DMINISTRATOR
F
UNCTIONS
C
HAPTER
7
153
Chapter 7 Administrator F
unctions
16.
Install the cover on the upper front panel of the welding power source.
17.
When the calibration has been completed, turn ON the breaker and the welding power source.
7.7.1.2 When the touch panel is installed on the welding power source
1.
Conduct steps 1 through 3 described in the previous section. ( 7.7.1.1 When the touch panel is installed on
the wire feeder)
2.
Press and hold the HOME key and the MENU key simultaneously and turn ON the power switch.

The "Special start up" screen appears.
3.
Select "16 Calibration mode".
4.
Conduct steps 10 through 13 described in the previous section. ( 7.7.1.1 When the touch panel is installed
on the wire feeder)
5.
When the calibration has been completed, turn OFF the power switch of the welding power source, and then
turn ON the power source again after the touch panel has completely turned off.
7.7.2 Adjustment of output voltage
7.7.2.1 When the touch panel is installed on the wire feeder
1.
Connect a following resistance load to the output terminal.
●
ARXIS WB-P403L:
0.1
Ω
, 12.6 kW or more
(If no resistance load is applied, open the circuit between the output terminals.)
ARXIS WB-P503L:
0.09
Ω
, 22.5 kW or more
(If no resistance load is applied, open the circuit between the output terminals.)
2.
Connect an external voltmeter and a voltage detection line to both ends of the resistance load (if no load is
applied, connect to the output terminal).
3.
Turn OFF the power switch.
4.
Turn OFF the breaker.