Daedong CK22, Руководство по ремонту

Страница: 111 / 372

2-59 DS35-W00 May. 2007
CLUTCHCLUTCHCLUTCHCLUTCHCLUTCH
TRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSIONTRANSMISSION
ENGINEENGINEENGINEENGINEENGINE
FRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLEFRONT AXLE
STEERINGSTEERINGSTEERINGSTEERINGSTEERING
BARKEBARKEBARKEBARKEBARKE
ELECTRICELECTRICELECTRICELECTRICELECTRIC
INDEXINDEXINDEXINDEXINDEX
HYDRAULICHYDRAULICHYDRAULICHYDRAULICHYDRAULIC
GENERALGENERALGENERALGENERALGENERAL
REAR AXLEREAR AXLEREAR AXLEREAR AXLEREAR AXLE
HSTHSTHSTHSTHST
CK22/CK22H
7.1.11 FLYWHEEL AND MAIN BEARING
CASE COVER
A. FLYWHEEL AND REAR PLATE
1. Loosen the flywheel bolt and remove the flywheel.
2. Loosen the bolt and remove the rear plate.
(When reassembling)
• Check the end of crankshaft any uneven wear, lack
or crack of teeth.
• Clean the end of crankshaft and the mating surface
of the flywheel.
• Apply oil to flywheel screws.
• To ease alignment of the crankshaft and the flywheel,
bring the crank of one of the cylinders to TC (top
dead center). Make sure of the flywheel TC, align it
with the punch mark of the rear and plate, and set
the flywheel.
• Tighten the flywheel bolts to in diagonal order.
NOTE:
• Screw longer screws to the flywheel to carry it, if
needed.
B. BEARING CASE COVER
Loosen the screws first inside and next outside, and
lift the cover (1) by screwing two screws gradually and
evenly, referring to the photo.
(When reassembling)
• Apply grease to the oil seal lip and take care that it
is not rolled when installing.
(1) Bearing case cover
196W298A
196W299A
Tightening torque
12.7 ~ 15.7 Nm
1.3 ~ 1.6 kgf-m
9.8 ~ 11.2 lb-ft
Item
Flywheel screw
Tightening torque
54 ~ 59 Nm
5.5 ~ 6.0 kgf-m
40 ~ 43 lb-ft
Item
Bearing case cover screw
(1) Rear plate
T46W2D3B
NOTE:
• When installing the main bearing case cover, the
“UP” mark on it should be at the highest position so
that its holes are aligned with the holes of the cylin-
der block.
up
ENGINE - SERVICING