Dacor RV30, Руководство по установке

Страница: 12 / 20

10
Locate the 3 ¼” X 10 duct mounting flange included 2.
with the unit. Attach it to the open exhaust hole using
the two (2) screws removed in step 1, with the flange
facing outward.
Locate the vent cover included with the unit. Also locate 3.
the supplied foam tape. Peel the backing off the tape
and attach it to the right and left flanges on the inside
of the vent cover.
Remove and retain the three (3) wing nuts from the top
4.
retainer bracket on the front of the unit. Remove the
bracket.
Slide the bottom flange of the vent cover into the bot-
5.
tom retainer bracket with the wiring diagram facing out.
Cover the opening on the front of the unit by pushing
6.
the vent cover against it.
Make sure that the foam tape on the cover creates a
7.
good seal on the right and left sides of the opening.
IMPORTANT: To prevent interference with the internal
moving parts, make sure the cover is properly centered
over the opening.
Reinstall the top retainer bracket over the top of the
8.
vent cover flange. Secure it in place with the three (3)
wing nuts removed in step 4.
Parts List
Product literature •
Vent cover •
Anchoring legs •
2 wood screws, #14 x 2 1/2 (PN 83047) •
3 wire nuts •
2 sheet metal screws, #10 x 1/2 (PN 83022) •
3 ¼” X 10 duct mounting flange •
2 keps nuts, 1/4-20 (PN 83049) •
2 flat washers, 1/4-20 (PN 83203) •
Insulation foam •
Installation Preparation
wARNING
If the electrical service does not meet the • Electrical
Specifications on page 4, do not proceed with the
installation. Call a licensed electrician to install an
electrical circuit that meets the specifications.
Install the vent only in a vertical orientation. Do not
•
mount the vent on a slant or angle.
Do not enlarge or modify the exhaust knock outs or
•
cut an exhaust hole in a location on the chassis other
than those shown. Doing so may cause an increase
in noise and decrease performance.
Loosely attach the anchoring legs to the studs on the •
left and right sides of the raised vent using the provided
keps nuts and washers.
Installation Preparation for Raised Vent with
ILHSF or REMP Series Blower:
NOTE: For units using the CABP3 cabinet blower, skip to
Installing the Vent in the Cutout on the next page.
Remove and retain the two (2) screws on the cover 1.
plate over the exhaust that will be used (bottom or
side). Discard the cover plate that was removed, but
leave the two other cover plates in place.
Installation Instructions
Bottom
cover
Exhaust Cover Removal (bottom shown)
Exhaust flange
Exhaust Flange Installation (bottom shown)
Adjustable
anchor legs
Front of
raised vent
Top retainer
bracket
Bottom retainer
bracket
Vent cover
Flange
Attach
foam to
right/left
flanges
Vent Cover Installation