Dacor RV30, Руководство по установке

Страница: 14 / 20

12
Installation Instructions
Duct Work Installation
Install the duct work from the raised vent to the point •
where it exits the building according to the Installation
Specifications . Use sheet metal screws and duct tape
to connect and seal all of the pieces. Support the duct
weight as necessary to ensure sealed joints.
On installations using a ILHSF or REMP series blower,
•
run the three conductor wiring required to power the
blower parallel to the duct work from the raised vent to
the blower. The wiring must meet the electrical speci-
fications on page 4 and local codes and ordinances.
Connect it as specified below.
Electrical Installation
wARNING
ELECTRIC SHOCK HAZARD • - Turn off power at the
circuit breaker panel or fuse box prior to connecting
the unit to the electrical circuit.
Do not ground the appliance with the neutral (white)
•
house supply wire. A separate ground wire must be
utilized.
Failure to complete electrical connections properly
•
may result in an electric shock hazard or a damaged
or non-functional system. Follow the wiring diagrams
carefully to ensure a proper installation. Do not
change the factory wired terminal connections inside
the electrical access panel for the raised vent or the
blower.
To avoid an electric shock hazard and to prevent
•
damage route all wiring away from hot surfaces.
Make sure power to the junction box that will sup- 1.
ply power to the raised vent is turned off at the circuit
breaker or fuse box.
Remove the screws from the front of the raised vent
2.
electrical access cover and remove it.
Connect the raised vent to the junction box accord-
3.
ing to Wiring Diagram B on the facing page and local
codes and ordinances. Make sure all terminal connec-
tions, including the factory wired connections, are tight.
On installations using an cabinet blower (CABP3): 4.
Remove the electrical access cover from the front •
of the blower.
Cut a piece of wire/conduit long enough to reach
•
from the power terminals inside the raised vent
to the power terminals inside the CABP3 blower,
via the electrical access holes on both units. The
location of the access hole on the CABP3 varies
depending on the blower orientation.
Connect the wiring/conduit that supplies power to the 5.
remote/in-line blower or cabinet blower (as applicable)
as shown in Wiring Diagram B on the facing page.
Replace the electrical access panel on the raised vent. 6.
Connect the blower power supply wiring from the raised 7.
vent to the blower:
On installations using a ILHSF or REMP series •
blower, connect the wiring according to the blower
installation instructions.
On installations using an cabinet blower, (CABP3)
•
connect the wiring according to Wiring Diagram A
on the facing page. Replace the blower electrical
access cover. Make sure all terminal connections,
including the factory wired connections, are tight.