Oven Maintenance
English
67
Removing/Re-installing the Oven Door
Spread a blanket on a stable, flat surface where you can lay the door once you have removed it.
CAUTION
The 30" oven door weighs 42 lbs (19 kg). Grasp the door with both hands. Do not lift by the handle.
1.
Open the oven door fully.
2.
In the bottom corners of the oven door, flip the
hinge locks toward you to unlock them. If the
hinge locks are not fully forward (see left), you
cannot remove the door.
3.
Partially close the door to engage the hinge
locks. (The door stops at this point.)
4.
Grasp the sides of the door below the handle,
and as you pull, gently jiggle the door side to
side as needed to loosen it.
5.
Set the door down without damaging the LED
cable at the door's bottom right corner.
6.
Disconnect the cable's wire harness, and set the
door (handle-down), on the blanket you prepared.
7.
When ready to re-install the door, stand at the top
of the door, grasp each side below the handles,
and take the door to the oven.
8.
Set the door down, and connect the wire harness.
9.
Holding the door at a 45° angle, insert the hinges
in the slots. (A slight drops engages the hinges.)
10.
Fully open the door. (If it does not open 90°,
repeat Steps 7 – 9.)
11.
Flip the hinge locks forward to lock them, and
close the door. (The gap between door and
control panel should be even; if not, the hinge on
the wide end of the gap is not seated properly.)
12.
Stuff the wire harness into its hole, and re-insert
the rubber seal.
Locked
Unlocked
Step 6
Step 8