xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
34
DHCP R
ELAY
C
OMMANDS
The DHCP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config dhcp_relay
{hops <value 1-16> | time <sec 0-65535>}
config dhcp_relay add ipif
<ipif_name 12> <ipaddr>
config dhcp_relay delete ipif
<ipif_name 12> <ipaddr>
config dhcp_relay option_82 state
[enable | disable]
config dhcp_relay option_82 check
[enable | disable]
config dhcp_relay option_82 policy
[replace | drop | keep]
show dhcp_relay
{ipif <ipif_name 12>}
enable dhcp_relay
disable dhcp_relay
Each command is listed in detail in the following sections.
config dhcp_relay
Purpose
Used to configure the DHCP/BOOTP relay feature of the Switch.
Syntax
config dhcp_relay {hops <value 1-16> | time <sec 0-65535>}
Description
This command is used to configure the DHCP/BOOTP relay feature.
hops <value 1-16>
Specifies the maximum number of relay agent
hops that the DHCP/BOOTP packets can cross. The range is from 1
to 16 hops, with a default setting of 4.
time <sec 0-65535>
The minimum time, in seconds, in which the
Switch must relay the DHCP/BOOTP packet. If this timer expires, the
Switch will drop the DHCP/BOOTP packet. The default setting is 0.
Restrictions Only
administrator-level users can issue this command.
Parameters
Example usage:
To config DHCP relay:
DES-6500:4#config dhcp_relay hops 2 time 23
Command: config dhcp_relay hops 2 time 23
Success.
DES-6500:4#
277