xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show ospf virtual_neighbor
Parameters
<area_id>
−
A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id>
−
The OSPF router ID for the neighbor. This is a
32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the remote area’s Area Border Router.
Restrictions None.
Usage Example
To display the current OSPF virtual neighbor table:
DES-6500:4#show ospf virtual_neighbor
Command: show ospf virtual_neighbor
Transit Router ID of IP Address of Virtual Neighbor
Area ID Virtual Neighbor Virtual Neighbor State
------------ ---------------- --------------- ----------------
10.1.1.1 10.2.3.4 10.48.74.111 Exchange
Total Entries : 1
DES-6500:4#
config ospf ipif
Purpose
Used to configure the OSPF interface settings.
Syntax
config ospf ipif <ipif_name 12> {area <area_id> | priority
<value> | hello_interval <sec 1-65535>| dead_interval <sec 1-
65535> | authentication [none | simple <password 8> | md5
<key_id 1-255>] | metric <value 1-65535> | state [enabled |
disabled]}
Description
This command is used to configure the OSPF interface settings.
Parameters
<ipif_name 12>
−
The name of the IP interface.
area <area_id>
- A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
priority <value>
−
The priority used in the election of the
Designated Router (DR). A number between 0 and 255.
hello_interval <sec 1-65535>
−
Allows the specification of the
interval between the transmission of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The
Hello Interval, Dead Interval, Authorization Type, and Authorization
Key should be the same for all routers on the same network.
dead_interval <sec 1-65535>
−
Allows the specification of the
length of time between the receipt of Hello packets from a neighbor
router before the selected area declares that router down. An
interval between 1 and 65535 seconds can be specified. The Dead
Interval must be evenly divisible by the Hello Interval.
315
