D-Link DWS-3160 Series, Справочное руководство CLI

Страница: 284 / 983

DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
280
If the relay servers are not determined either by Option 60 or Option 61, then per IPIF configured
servers will be used to determine the relay servers.
Format
config dhcp_relay option_60 state [enable | disable]
Parameters
state - Specifies that the DHCP relay function should use the Option 60 rule to relay the DHCP
packets.
enable - Specifies that the Option 60 rule will be enabled.
disable - Specifies that the Option 60 rule will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the state of DHCP relay Option 60:
DWS-3160-24PC:admin# config dhcp_relay option_60 state enable
Command: config dhcp_relay option_60 state enable
Success
DWS-3160-24PC:admin#
24-12 config dhcp_relay option_60 add
Description
This command is use to configure the Option 60 relay rules.
NOTE: Different string values can be specified using the same relay server, and the
same string can be specified with multiple relay servers. The system will relay the
packet to all the matching servers.
Format
config dhcp_relay option_60 add string <multiword 255> relay <ipaddr> [exact-match |
partial-match]
Parameters
string - Specifies the string used.
<multiword 255> - Enter the string value here. This value can be up to 255 characters long.
relay - Specifies a relay server IP address.
<ipaddr> - Enter the IP address used for this configuration here.
exact-match - The Option 60 string in the packet must full match with the specified string.
partial-match - The Option 60 string in the packet only need partial match with the specified
string.