D-Link DWS-1008, Справочное руководство CLI

Страница: 326 / 531

D-Link DWS-1008 CLI Manual
set {ap | dap} group
Configures a named group of AP access points. MSS automatically load balances sessions
among the access points in a group. To balance the sessions, MSS rejects an association request
for an access point’s radio if that radio has at least four more active sessions than the radio of the
same type with the least number of active sessions within the group.
Syntax: set {ap
port-list
| dap {
dap-num
| auto}} group
name
ap
port-list
dap
dap-num
dap auto
name
Defaults: AP access points are not grouped by default.
Access: Enabled
Usage: You can assign any subset or all of the access points connected to a DWS-1008 to a
group on that switch. All access points in a group must be connected to the same DWS-1008.
If you use the name none, spelled in any combination of capital or lowercase letters, the specified
access point is cleared from all AP groups.
Examples: The following command configures an DWL-8220AP access point group named
loadbalance1 that contains the access points on ports 1, 4, and 7:
DWS-1008# set ap 1,4,7 group loadbalance1
success: change accepted.
See Also:
• show {ap | dap} config
• show {ap | dap} group
List of AP access ports to add to the group.
Number of a Distributed AP to add to the group.
Configures an AP group for the AP configuration profile.
AP access point group name of up to 16 alphanumeric characters, with
no spaces.