D-Link DWS-1008, Справочное руководство CLI

Страница: 56 / 531

D-Link DWS-1008 CLI Manual
set port type wired-auth
Configures an DWS-1008 port for a wired authentication user.
Syntax: set port type wired-auth port-list [tag tag-list ] [max-sessions num ]
[auth-fall-thru {last-resort | none | web-portal}]
port-list
tag-list
num
last-resort
none
web-portal
Defaults: The default tag-list is null (no tag values). The default number of sessions is 1. The
default fallthru authentication type is none.
Access: Enabled.
Usage: You cannot set a port’s type if the port is a member of a port VLAN. To remove a port
from a VLAN, use the
clear vlan command. To reset a port as a network port, use the clear
port type command.
When you change port type, MSS applies default settings appropriate for the port type.
The following Table lists the default settings that MSS applies when you set a port’s type to
wired-auth.
Wired Authentication Port Defaults:
List of physical ports.
One or more numbers between 1 and 4094 that subdivide a wired
authentication port into virtual ports.
Maximum number of simultaneous user sessions supported.
Automatically authenticates the user without requiring a user name and
password.
Denies authentication and prohibits the user from accessing the network
over this port.
Serves the user a web page from the DWS-1008’s nonvolatile storage
for a secure login to the network.
Port Parameter Setting
VLAN Membership
Removed from all VLANs. You cannot assign an AP access port to a
VLAN. MSS automatically assigns AP access ports to VLANs based on
user traffic.
Spanning Tree Protocol
(STP)
Not applicable.
802.1x Uses authentication parameters configured for users.
Port Groups
Not applicable.
IGMP Snooping
Enabled as users are authenticated and join VLANs.
Maximum user
sessions
One (1)
Fallthru Auth type None