D-Link DWS-1008, Справочное руководство CLI

Страница: 390 / 531

D-Link DWS-1008 CLI Manual 8
name
11a | 11b | 11g
mandantory
rate-list
disabled
rate-list
beacon-rate
rate
multicast-rate
{
rate | auto}
Service profile name.
Radio type.
Set of data transmission rates that clients are required to support in
order to associate with an SSID on an AP. A client must support at
least one of the mandatory rates.
These rates are advertised in the basic rate set of 802.11 beacons,
probe responses, and reassociation response frames sent by AP
radios.
Data frames and management frames sent by APs use one of the
specified mandatory rates. The valid rates depend on the radio type:
• 11a - 6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
•
11b - 1.0, 2.0, 5.5, 11.0
• 11g- 1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
Use a comma to separate multiple rates; for example:
6.0,9.0,12.0
Data transmission rates that APs will not use to transmit data. This
setting applies only to data sent by the APs. The radios will still accept
frames from clients at disabled data rates.
The valid rates depend on the radio type and are the same as the
valid rates for
mandatory.
Data rate of beacon frames sent by APs. This rate is also used for
probe-response frames.
The valid rates depend on the radio type and are the same as the
valid rates for
mandatory. However, you cannot set the beacon rate
to a disabled rate.
Data rate of multicast frames sent by APs.
• rate - Sets the multicast rate to a specific rate. The valid rates depend
on the radio type and are the same as the valid rates for mandatory.
However, you cannot set the multicast rate to a disabled rate.
•
auto - Sets the multicast rate to the highest rate that can reach all
clients connected to the AP.