D-Link DWS-1008, Справочное руководство CLI

Страница: 133 / 531

D-Link DWS-1008 CLI Manual 10
Example: The following command adds a default route that uses default router 10.5.4.1 and
gives the route a cost of 1:
DWS-1008# set ip route default 10.5.4.1 1
success: change accepted.
The following commands add two default routes, and configure MSS to always use the route
through 10.2.4.69 when the switch interface to that default router is up:
DWS-1008# set ip route default 10.2.4.69 1
success: change accepted.
DWS-1008#
set ip route default 10.2.4.17 2
success: change accepted.
The following command adds an explicit route from a switch to any host on the 192.168.4.x
subnet through the local router 10.5.4.2, and gives the route a cost of 1:
DWS-1008# set ip route 192.168.4.0 255.255.255.0 10.5.4.2 1
success: change accepted.
The following command adds another explicit route, using CIDR notation to specify the subnet
mask:
DWS-1008# set ip route 192.168.5.0/24 10.5.5.2 1
success: change accepted.
set ip snmp server
Enables or disables the SNMP service on the switch.
Syntax: set ip snmp server {enable | disable}
enable
Enables the SNMP service.
disable
Disables the SNMP service.
Defaults: The SNMP service is disabled by default.
Access: Enabled.
Examples: The following command enables the SNMP server on a DWS-1008 switch:
DWS-1008# set ip snmp server enable
success: change accepted.