D-Link DWS-1008, Справочное руководство CLI

Страница: 60 / 531

D-Link DWS-1008 CLI Manual
show port poe
Displays status information for ports on which Power over Ethernet (PoE) is enabled.
Syntax: show port poe [ port-list ]
port-list List of physical ports. If you do not specify a port list, PoE information is displayed
for all ports.
Defaults: None.
Access: All.
Examples: The following command displays PoE information for all ports on a DWS-1008:
DWS-1008# show port poe
Link Port PoE PoE
Port Name Status Type config Draw
==============================================================
1 1 up - disabled off
2 2 down - disabled off
3 3 down - disabled off
4 4 down - disabled off
5 5 down - disabled off
6 6 up AP enabled 1.44
7 7 down - disabled invalid
8 8 down - disabled invalid
The table below describes the fields in this display.
Field Description
Port Port number.
Name Port name. If the port does not have a name, the port number is
listed.
Link status Link status of the port:
• up—The port is connected.
• down—The port is not connected.
Port type Port type:
• AP—The port is an AP access port.
• - (The port is not an AP access port.)
PoE config PoE state:
• enabled
• disabled
PoE Draw Power draw on the port, in watts.
For 10/100 Ethernet ports on which PoE is disabled, this field
displays off. The value overcurrent indicates a PoE problem
such as a short in the cable.