D-Link DGS-3700 Series, Справочное руководство

Страница: 53 / 557

DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Page | 53
S
WITCH
U
TILITY
C
OMMANDS
Back to Section Header
The switch utility commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
C
OMMAND
P
ARAMETERS
download [ firmware_fromTFTP [<ipaddr> |<ipv6addr>] src_file <path_filename
64> {image_id <int 1-2>} | cfg_fromTFTP [<ipaddr> |<ipv6addr>]
src_file <path_filename 64> {[<config_id 1-2> | increment]} ]
config firmware image_id <int 1-2> [delete|boot_up]
show firmware information
show config [[effective | modified | current_config | config_in_nvram <config_id 1-2>]
{ [include | exclude| begin] <filter_string 80> {<filter_string 80>
{<filter_string 80>} } { [include | exclude | begin ] <filter_string 80>
{<filter_string 80> {<filter_string 80>} } { [include | exclude | begin ]
<filter_string 80> {<filter_string 80> {<filter_string 80>}}}}}]
upload [ cfg_toTFTP [<ipaddr> |<ipv6addr>] dest_file <path_filename 64>
{ <config_id 1-2>} { [include | exclude| begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>} } { [include | exclude | begin ]
<filter_string 80> {<filter_string 80> {<filter_string 80>} } { [include |
exclude | begin ] <filter_string 80> {<filter_string 80> {<filter_string
80>} } } } } | log_toTFTP [<ipaddr> |<ipv6addr>] dest_file
<path_filename 64> | attack_log_toTFTP [<ipaddr> |<ipv6addr>]
dest_file <path_filename 64> ]
enable autoconfig
disable autoconfig
show autoconfig
config configuration <config_id 1-2> [boot_up | delete | active]
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
ping6 <ipv6addr> {times <value 1-255>| size <value 1-6000>| timeout <value 1-
10>}
traceroute <ipaddr> {ttl <value 1-60>} {port <value 30000-64900>} {timeout <sec
1-65535>} {probe <value 1-9>}
traceroute6 <ipv6addr> {ttl <value 1-60> | port <value 30000-64900> | timeout <sec
1-65535> | probe <value 1-9>}
telnet <ipaddr> {tcp_port <value 0-65535>}
Each command is listed, in detail, in the following sections.
download
Purpose
Used to download and install new firmware or a Switch configuration file from a
TFTP server.
Syntax download [ firmware_fromTFTP [<ipaddr> |<ipv6addr>] src_file
<path_filename 64> {image_id <int 1-2>} | cfg_fromTFTP [<ipaddr>
|<ipv6addr>] src_file <path_filename 64> {[<config_id 1-2> | increment]}]
Description This command is used to download a new firmware or a Switch configuration file
from a TFTP server.