DGS-3700 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
Page | 528
DGS-3700-12G:5#show cfm fault
Command: show cfm fault
MD Name MA Name MEPID Status AIS Status LCK Status
----------- ----------- ----- ---------------------- ------------ ------------
DGS-3700-12G:5#
show cfm port
Purpose
This command is used to show MEPs and MIPs created on a port.
Syntax
show cfm port <port> {level <int 0-7> | direction [inward | outward] | vlanid
<vlanid 1-4094>}
Description
This command is used to show MEPs and MIPs created on a port.
Parameters
port
– Specifies the port number.
level
– Specifies the MD Level. If not specified, all levels are shown.
direction
– Specifies the MEP direction.
inward
– Inward facing MEP.
outward
– Outward facing MEP.
If not specified, both directions and MIPs are shown.
Vlanid
– VLAN identifier. If not specified, all VLANs are shown.
Restrictions
None.
Example usage:
To display CFM ports:
DGS-3700-12:4#show cfm port 1
Command: show cfm port 1
MAC Address: 10:10:90:08:8g:12
MD Name MA Name MEPID Level Direction VID
----------- ----------- ----- ----- --------- ----
op_domain op1 1 2 inward 2
cust_domain cust1 8 4 inward 2
serv_domain serv2 MIP 3 2
DGS-3700-12:4#
show cfm mipccm
Purpose
This command is used to show MIPCCM database entries.
Syntax
show cfm mipccm
Description
This command is used to display all entries in the MIPCCM. The MIPCCM entry is
similar to FDB which keeps the forwarding port information for a MAC entry.
Parameters
None.
Restrictions
None.
Example usage:
To display the MIPCCM database entries:
