CYP SDV-CS8, Руководство по эксплуатации

Страница: 32 / 48

32
■ Wall Size:
Select the size of the video wall, measured in number of
monitors tall by number of monitors wide. The maximum number
of displays in a single video wall is 64 (8x8).
Note: The source will be stretched to fill the entire video wall. Selecting
a non-square configuration of monitors may result in the image being
distorted.
■ Bezel Top/Bottom/Left/Right:
Set the size, in pixels, of the bezel
surrounding the monitors used in the video wall.
Note: It is strongly recommended to use the same make and model
for all monitors within a video wall to avoid bezel and panel size
discrepancies.
■ Receiver Selection:
This is a list of all available receivers in the
system. Drag and drop each receiver to it’s correct position within
the video wall grid to the right of the list. After placement, each
receiver’s name will be displayed within the selected location of
the video wall and it will turn green. Blue panels within the video
wall indicate that no display has been assigned to it yet, and red
panels indicate that a display has been assigned, but is not in the
correct mode.
■
Save Preset: Click this button to save changes to the current video
wall configuration without executing or activating it.
■ Execute:
Click this button to save changes to the current video
wall configuration and then execute the changes. If the video wall
was not already active, this will also activate it.