CYP SDV-CS8, Руководство по эксплуатации

Страница: 15 / 48

15
2) HDMI Audio Routing: Provides drag-and-drop control over the
independent HDMI audio routing of all detected transmitters and
receivers.
Note: Bitstream audio is only supported when the receiver’s HDMI audio
device setting is set to “HDMI Audio (Follow Video in Genlock Mode)”.
■
HDMI Audio Transmitter: This section provides drag-and-drop
buttons for all transmitters detected by the system as well as a
button target to stop one or all independent HDMI audio streams
from being transmitted.
Source to Single Receiver Routing:
To route an HDMI audio
source to a receiver, click and drag the source’s button on the left
to the preferred display on the right side, then release the mouse
button. If the routing was completed successfully, the newly
routed source’s name will appear below the display’s name within
the button. Clicking on any source button will change the colour
of itself, and all currently routed displays.
Note: Receivers may also be drag and dropped onto sources to
activate a new route.
Source to Multiple Receiver Routing:
To route an HDMI audio
source to multiple receivers at the same time, click and drag the
source’s button on the left to the “All” button on the right side,
then release the mouse button. If the routing was completed
successfully, the source’s name will appear within all appropriate
buttons.