Parameter
Name
Description
Setting Range
Decimal Places
Max.: 3
o2: Multi-Function Selection
o2-00
LO/RE
(LOCAL/REMOTE)
Key Function
Selection
Enables or disables LO/RE key on the keypad.
0
∶
Disabled
1
∶
Enabled
Switches between Local and Remote
Operation
Default: 1
Range: 0, 1
o2-01 STOP Key Function
Selection
Enables or disables the STOP key on the keypad
when the controller is controlled from a remote
source.
0
∶
Disabled
1
∶
Enabled
The STOP key always stops controller
operation even if the command source is not
set to the keypad.
Default: 1
Range: 0, 1
o2-03
<2>
Controller Capacity
Selection
Set this parameter after replacing the terminal
block or controller modules.
Default: <2>
Determined by
controller capacity
o2-04
ENTER Key
Function During
Frequency
Command Setting
0
∶
ENTER Key Required
1
∶
ENTER Key Not Required
When entering a frequency command, the
output frequency changes immediately by UP
or DOWN key without pressing ENTER.
Default: 0
Range: 0, 1
o2-05
<7>
Action Select
When LCM Keypad
Disconnection
0
∶
Disabled
1
∶
Enabled
Default: 0
Range: 0, 1
o2-06
Operation
Direction at Power
Up when Using
Keypad
0
∶
Forward
1
∶
Reverse
This parameter is enabled only when the
keypad is selected as the Run command source.
Default: 0
Range: 0, 1
o4: Maintenance Settings
o4-00
Cumulative
Operation Time
Setting
Sets the initial value by 10 hours to start
keeping track of cumulative operation time.
Default: 0 h
Min.: 0 h
Max.: 6000 h
o4-01
Cumulative
Operation Time
Selection
Selects the conditions in which the controller
keeps track of the cumulative operation time.
0
∶
Time of Power On
Keeps track of time from the power up to
power cutoff.
Default: 0
Range: 0, 1
Содержание CPSPI3700EVF380
Страница 7: ...6 WarningLabel ...
Страница 31: ...30 Figure 4 4 4 DIP Switch RS 485 Termination Resistor OFF ON ...
Страница 94: ......