P/N IM-C35KD Rev. C
2014 Commercial Wireless Systems International, LLC.
39
screens. Only the first 5 (01-05) will apply to the RM-5. The screens will advance through all 40 relays
even if you have less than 40 connected. The options for the relay box and RM-5 relays are the same
as the NAC selections.
When you have finished making the desired changes press the SAVE soft key. This will automatically
put you on the Select Repeater to Program screen. If you press BACK without saving you will be
prompted to save. If you make many changes on multiple screens before saving there will be a delay
after pressing the SAVE soft key before the screen changes to one level back. Be patient and do not
press the SAVE soft key multiple times. Once the changes are stored the Select Repeater to Program
screen will appear. When you save the changes they are sent via RF signal to the repeater. If you try
to edit a relay which was just edited and saved, the CP-3500D will not let you change the
programming again until it has finished sending the previous information to the repeater. A message
will appear just under the NAC RLY XX line at the top of the screen which reads Last Update
Pending, Unable to Edit. If this occurs back out of the relay edit screen and wait a few minutes then
try again. You will be allowed to edit the information once the CP-3500D is finished programming the
current information into the repeater.
4.6 CP-3500D Auxiliary Output and Dry Contact Relay
Programming
This section contains instructions on how to program the Relay 1, Relay 2 and Auxiliary outputs
located on the CP-3500D main board. The other outputs on the CP-3500D main board are not
programmable. Application information for these outputs can be found in the Systems Outputs section
of this manual.
4.6.1 Accessing the CP-3500D Relay Setup Screen
To access the CP-3500D relay setup screen, press the program soft key on the main system normal
screen. Scroll down to CP-3500D Setup and press ENTER. The CP-3500D setup menu will now be
displayed. Highlight CP-3500D Relay Setup and press ENTER. The following screen will be
displayed.
C P - 3 5 0 0 D Re l a y S e t u p
Cancel
T u r n “ O n ” S ig n a l
Re l a y 1 : X
Re l a y 2 : X
A u x O u t p u t : X
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
T u r n “ O f f ” B u t t o n
Re l a y 1 : S ig n a l S i l e n c e
Re l a y 2 : S ig n a l S i l e n c e
A u x O u t p u t : S ig n a l S i l e n c e
Содержание CP-3500D
Страница 12: ...P N IM C35KD Rev C 2014 Commercial Wireless Systems International LLC 12 Figure 1...
Страница 21: ...P N IM C35KD Rev C 2014 Commercial Wireless Systems International LLC 21 Figure 2...
Страница 47: ...P N IM C35KD Rev C 2014 Commercial Wireless Systems International LLC 47 Figure 4...
